This article mainly introduces:

Ghana hydraulic cylinder,metallurgical cylinder manufacturer,metallurgical cylinder

(Ghana metallurgical cylinder,produced by Hebei Hengyu company）

metallurgical cylinder are widely used in Ghana，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed metallurgical cylinder for customers from Ghana.

Introduction to metallurgical cylinder:

When installing the metallurgical cylinder pipe, the pipe should be cleaned after installation, and should not pass through the metallurgical cylinder block, and the by-pass pipe must be installed in front of the oil port of the metallurgical cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the metallurgical cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the metallurgical cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

The repair method of the metallurgical cylinder: the repair of the metallurgical cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

Do not enter foreign bodies when installing the metallurgical cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

How the cavitation of the metallurgical cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the metallurgical cylinder, resulting in corrosive damage to the parts.

Answers to some questions about metallurgical cylinder:

What is the main maintenance of the cylinder?
After disassembling the cylinder: 1, clean the cylinder and piston; 2, replace all seals; 3, if there is a valve to repair, to ensure sealing and flexible; 4, deal with all deformation parts; 5. Installation experiment.

What is the meaning of cylinder HSGK01-100/70E-4111-1320?
hsg Double acting single piston rod hydraulic cylinder and front end cover are connected by internal clamp key 01 Design serial number 100 cylinder inner diameter 70 piston rod outer diameter e Pressure class code 16mpa4111 Front flange, rod end external thread, both ends with buffer, oil port connection is internal thread 1320 stroke.