日女人逼,日韩av免费在线观看,AV小网站,奶水孕妇挤胸喷奶水AV

High quality hydraulic equipment manufacturers!
TELL:+8613184968882

vehicle hydraulic cylinder Sold to Uzbekistan

Release time:2023-11-10 08:34:53 Hits: Current position: Home > News

This article mainly introduces:

Uzbekistan hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

Uzbekistan vehicle hydraulic cylinder

(Uzbekistan vehicle hydraulic cylinder,produced by Hengyu Group)

vehicle hydraulic cylinder are widely used in Uzbekistan,because of excellent temperature resistance,no transmission clearance,powerful torque.So our company has designed vehicle hydraulic cylinder for customers from Uzbekistan.

Introduction to vehicle hydraulic cylinder:

If the vehicle hydraulic cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

The vehicle hydraulic cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the vehicle hydraulic cylinder should pay attention to: the operation should be as far away from the vehicle hydraulic cylinder as possible, to avoid falling objects, knocking, rubbing the vehicle hydraulic cylinder coating. When cleaning the vehicle hydraulic cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the vehicle hydraulic cylinder when the oil temperature exceeds 70 ° C.

Because of the slightly complex structure of the buffer vehicle hydraulic cylinder, sometimes there will be problems, such as when the vehicle hydraulic cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

vehicle hydraulic cylinder body inspection: The inner surface of the vehicle hydraulic cylinder and the piston seal are the main factors causing the leakage in the vehicle hydraulic cylinder, if the vehicle hydraulic cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the vehicle hydraulic cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

Answers to some questions about vehicle hydraulic cylinder:

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.

There are four cylinders in the front top of the dump truck. When the second cylinder is lifted to half the height, it suddenly falls back more than 30 cm or so, and the cylinder continues to lift.
The problem is the cylinder, the second section of the different strength of the heart. When the oil supply resistance is small, the first out, when the power is not moving, the cylinder needs to be strong, because the second section needs to pop it out after a while when the pressure is large, the oil can not keep up, so it falls back, and the oil continues to keep up.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP
国产乱色精品成人免费视频| 国产成人精品日本亚洲专区61| 91视频一区二区| 无职转生第一季完整在线观看高清| 小蜜桃1| 偷拍 日韩 欧美| 成人无码福利另类一区二区| 欧美色老妇xxx| 鹤岗市| 精品国产久| 日韩精品一区二区亚洲AV观看| 午夜神马福利| 99久久中文| 久九精品| 乱伦肏屄视频| 成人av动漫| 国产精品videosex极品| 五月婷婷日本| 午夜影视大鸡巴| 天堂在\/线中文官网| 二区国产| 夫妻在线不卡| 商河县| 人妻少妇88久久中文字幕 | 色呦呦在线观看视频| 八点影院| 69久久夜色精品国产69| 大伊人国产| 国产毛片久久| 国产又黄又刺激网站| 午夜女人| 综合婷婷色| 少妇人妻精品久久久久久| www.日韩无码精品| 激情麻豆| 国产成a人亚洲精v品在线观看| 二区综合网| 深夜影院| av老司机| 亚洲第一色天堂av| 丁香婷婷五月婷婷|